forum veteran tatra

forum o veteránech tatra, srazech veteránů a oprav a náhradních dílech na veterány

Whitworth

Vzájemná poradna fandů dvouválců!

Whitworth

Příspěvekod fobos07 » úte 29. zář 2015 21:35:29

Dobrý den,
v jakém období a podle jaké normy používali v Tatře Whitworth? Vyrábí/prodává tyto předválečné spojováky u nás někdo?
Na Tatře 12 z roku 1928 jsou na motoru např. matky BSW 5/16-18 na klíč 15 mm vysoké 8 mm. Na takový závit lze koupit závitníky, očka i šrouby a matky. Matky a hlavy šroubu jsou ale menší. Na anglických stránkách je popsané, jak na počátku války z důvodu úspory materiálu zmenšily všechny hlavy o jedno číslo.

http://www.oldengine.org/members/diesel ... WhitAF.htm
http://www.enginehistory.org/BSFastener ... ence_3.pdf

http://www.torqueleader.com/linkservid/ ... howMeta/0/

From the front page of this website
http://www.baconsdozen.co.uk/

"B.S.W. or Whitworth
British Standard Whitworth,an early English thread standard,found on many veteran machines. Threads are coarse,angle 55degrees and the pitch is measured in threads per inch.The size marked on the spanner (half inch whitworth,nine sixteenths whitworth etc) refers to the diametre of the shank of the bolt it fits not the head size and is always in fractions of an inch. For this reason a Whitworth spanner or socket is always larger than AF ones carrying the same size markings.All Whitworth tools will carry a marking,normally a fraction followed by "W", "WHIT" or Whitworth and sometimes "W/BSF" . Pretty much obsolete by the mid 60s but still found on some cars,motorcycles trucks,trains and machinery made after this. During the second world war the sizes of the heads of BSW and BSF bolts were reduced to save metal,all nuts and bolts were made one size smaller (ie) a 'new' 1/2 whit bolt had the same size head as the old 7/16.The war also emphasised the need for a universal standard in bolt sizes which eventually resulted in the introduction of the 'Unified' system which utilises AF spanners and sockets.
B.S.F.
British Standard Fine,in effect,a fine version of whitworth. Size again refers to the thread part of the bolt,not the head. BSF spanners are always marked one size larger than the same sized BSW spanner so for example a 1/4 inch BSW is the same size as a 5/16 inch BSF."

V Anglii existuje i pár nadšenců co spojováky podle předválečných norem prodávají:
http://www.heritagesteamsupplies.co.uk/
http://www.steamsupplies.co.uk/

Děkuji za radu
Fobos07
fobos07
 
Příspěvky: 3
Registrován: pát 13. úno 2015 19:35:58

Zpět na Tatra 11,12,13

Kdo je online

Uživatelé procházející toto fórum: Žádní registrovaní uživatelé a 7 návštevníků

cron